Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Airshroud
Backplane Cover
Identify the backplane cover highlighted in blue
Slide and lift the backplane cover in the direction of the arrows marked on the backplane cover.
cooling fan assembly
Identify the Cooling Fan Assembly highlighted in blue.
Lift the blue release levers to unlock the cooling fan cage assembly from the system.
Hold the release levers, and lift the cooling fan cage assembly away from the system.
Control panel -Right
Identify the control panel highlighted in blue
Remove the screws that secure the control panel cable cover to the system
Remove the cable cover away the system.
Remove the screws that secure the control panel assembly to the system.
Press the tab to release the side wall bracket cover.
Unroute the cables to release them from the side wall bracket.
Disconnect the right control panel cable and the VGA cable from the connectors on the system board.
Unroute the control panel cable and VGA cable from the side wall of the system.
Holding the cable, slide the right control panel out of the system.
Install
Control panel -Right
Identify the control panel location highlighted in blue
Align the right control panel assembly with the slot and slide into place
Route the control panel cable and VGA cable through the side wall of the system.
Connect the right control panel cable and VGA cable to the connectors on the system board.
Route the cables through the side wall bracket.
Close the side wall bracket cover with your thumbs until the cover firmly clicks into place.
Install the screws to secure the control panel to the system.
Align and slide the right control panel cable cover in the slot on the system.
Install the screws to secure the control panel cable cover to the system.
cooling fan assembly
Identify the Cooling Fan Assembly location highlighted in blue.
Align the guide rails on the cooling fan cage assembly with the standoffs on the system.
Lower the cooling fan cage assembly into the system until the cooling fan cage connectors engage with the connectors on the system board.
Press the release levers to lock the cooling fan cage assembly into the system.
Backplane Cover
Identify the backplane cover location highlighted in blue
Slide the backplane cover toward the front of the system until the cover locks into place.
Airshroud
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.